AEROPAK metallic spray paint can provide vivid electroplating effect, which can replace the
traditional chroming techniques. It is able to effectively resist
UV radiation, enhance the aging-resistance of the decorated goods
and prevent eroding. It can be widely applied to metals, wood,
glass, ABS and other surfaces. The film finish has excellent
hardness, adhesion and flexibility. The film should avoid scrubbing
or clashing to prevent the damage of its metal effect.
Specifications
| Brand Name | Aeropak | | Model Number | APK-8104 |
| Colors | Chrome | | Spray Rate | >98% |
| Coverage | about 2 square meters/can | | Tack Free Time | < 5 minutes |
| Surface dry time | < 5 minutes | | Hard Dry Time | < 1 hour |
| Adhesiveness | Good | | Main ingredients | resine, solvent, pigment, LPG |
PREPARATION
For best results, clean surface of grease, wax, rust and dust.
Scuff or lightly sand all glossy surfaces removing any unwanted
bumps or flaking paint, then dust off. Prime raw timber or metal
with Aeropak primer and allow to fully dry.
APPLICATION
IMPORTANT : Shake the can vigorously for one minute before use.
Holding the can 30cm from prepared surface, begin by applying one
light mist coat, spraying in a continuous motion across the surface
working left to right. Pause, allowing the mist coat to set for 30
to 60 seconds, then apply additional coats working at 90° to the
first coat. If a thicker finish is required, allow at least one
hour between extra coats. When painting over existing paint always
check compatibility.
For best results, clean surface of grease, wax, rust and dust.
Scuff or lightly sand all glossy surfaces removing any unwanted
bumps or flaking paint, then dust off. Prime raw timber or metal
with Aeropak primer and allow to fully dry.
DIRECTIONS
1. Remove thoroughly the oil, soil, water stain and dust from the
surface to be sprayed.
2. Shake the can well for about half a minute before spraying.
3. Apply first on an invisible part to make sure the selected color
is well matched
4. Keep 15-30 cm away from the surface to be sprayed.
5. In case of little paint or only gas out, turn the nozzle 180°
and try again.
6. During spraying, keep the can upright within a vertical angle of
45°.
7. After use, clear the valve and nozzle by spraying upside down
for a few seconds.
Precautions
1. Content under pressure. Keep away from heat, flame, spark and
other source of ignition.
2. Do not spray on objects with direct contact of food.
3. Spray in well-ventilated place. A better coating effect will be
gained if operate in a cool, dry and dustless environment.
4. Avoid applying the lacquer on a rainy or freezing day.
5. Do not clash, puncture, or incinerate the can, even after use.
6. Store in a cool, dry place (45°C); Avoid direct sunlight.
7. Keep out of the reach of children
CORRECT DISPOSAL
Spray unneeded product on to newspaper dispose to waste.
Empty can is recyclable.
SAFETY WARNINGS
Keep out of reach of children
If swallowed seek medical advice immediately.
Warning - intentional misuse by deliberately inhaling contents
can be harmful or even fatal.
Package & Shipping
Certificate
